[vc_row][vc_column][vc_column_text]
This tutorial will show how to test/change light and temperature with LDR Module and Linker_Temp via IOIOTempLight
[/vc_column_text][/vc_column][/vc_row][vc_row][vc_column width=”1/1″][vc_tour][vc_tab title=”Hardware list” tab_id=”1390384551-1-77″][vc_column_text]
1*pcDuino V1 with Android system
1*IOIO_OTG
1*LDR Module（light sensor）
[/vc_column_text][/vc_tab][vc_tab title=”Set up” tab_id=”1390384551-2-62″][vc_column_text]1. Installed IOIO Temp Light.apk on pcDuino, then clink the icons and run
2. Circuit
Linker -temp VCC →IOIO-OTG 5V
Linker -temp GND→IOIO-OTG GND
Linker -temp output→IOIO-OTG pin 34
light sensor SIG→IOIO-OTG pin 35 (IOIO-OTG’s pin 31-46 are enable)
3. Connected pcDuino and IOIO-OTG via USB. Open IOIO Temp Light.apk APP
4. Display
5. Moving fired lighter close light sensor.
[/vc_column_text][/vc_tab][/vc_tour][/vc_column][/vc_row]
Leave a Reply
You must be logged in to post a comment.