[vc_row][vc_column][vc_column_text]This is a post following the previous one: http://learn.linksprite.com/scratch/synthesize-color-by-rgb-leds-a-scratch-for-pcduino/

[/vc_column_text][/vc_column][/vc_row][vc_row][vc_column width=”1/1″][vc_tour][vc_tab title=”Part list” tab_id=”1400209985-1-28″][vc_column_text]

1. 1  x  pcDuino
2. 3  x  LED Module of Linker Kit for pcDuino/Arduino ( RED, YELLOW,BLUE Respectively)
3. 3  x   20 cm cable for Linker Kit
4. 1  x Linker base

[/vc_column_text][/vc_tab][vc_tab title=”Script” tab_id=”1400209985-2-93″][vc_column_text]1. Choose the  , then click the , to draw the Red LED script, as the follows

2. Set the initial state of the Red LED

When the green flag is clicked, the costumer 1 is hollow, then the set of red light is  off

3. when the role 1 is clicked, switch to the next costumer, so you can switch back and forth from both costumers, when costumer 2 turn on ,so  set 

Or the costumer 1 is off, so set

4.The control principles of the three LED are the same, so copy these script  to  role 2 and  role 3.

Note: after you copy the script to role 2 and role 3 you need to change the pin port

[/vc_column_text][/vc_tab][vc_tab title=”Result” tab_id=”1400210331175-2-1″][vc_column_text]When you click the green flag

After you click the edge of the LED，you will see

[/vc_column_text][/vc_tab][vc_tab title=”Download” tab_id=”1400474143213-3-3″][vc_column_text]Project files[/vc_column_text][/vc_tab][/vc_tour][/vc_column][/vc_row]