The Palace Cinema has just opened up in IoL City! It needs spectacular lights for its grand premiere.
Use a Wio Link board to remotely control addressable LEDs for the cinema roof and marquee.
- Wio Link
- ESP8266 based IoT platform
- Addressable LEDs
- NodeJS platform for programming the IoT
- LEGO® Palace Cinema
- Expert modular series
I just got my hands on a Wio Link Starter Kit. It’s a simple to use system composing of an ESP8266 based development board, Grove modules and supporting platform for interacting with the chip and cloud hosted API. Although I’m quite familiar with programming the embedded side of IoT components, it does however take a lot of time and additional languages to get familiar with. This kit skips those steps, providing a familiar RESTful API and drag n’ drop firmware builder, via a phone app.
This project is pretty much about playing with the new gear to see how it all works and having fun along the way.
I followed the instructions on their getting started guide. It basically involves downloading the mobile app (Android/iOS), discovering the WiFi SSID that the dev board is broadcasting, connecting and configuring it as a WiFi client to your network.
Once configured, the device is programmed by dragging a sensor image to the GPIO Grove connection.
Update the firmware to commit the changes.
The API button will now show you how to interact with the project. It even has a built-in API tester, which is super helpful.
The kit comes with a strip of 30 waterproof WS2812 LEDs. I initially used this as my test, but I already had a non enclosed strip with a higher density of LEDs. These will integrate into the cinema a little better.
How do they work? By shifting the 24 bit address once each time the signal goes through an LED (from DIn to DOut), the next light will get the correct data. Make sure to connect the input signal to D1. My first attempt failed because I assumed DO was D0 (zero).
I first connected the LED strip to one of the Grove interfaces and a temp & humidity sensor to another. After playing around for a while to get familiar with it, I figured out the basic goals and capabilities of the project. (This project does not make use of of the temp&hum sensor)
I had a spare addressable LED strip so I cut it down to size. There are 8 LEDs for each roof side, 7 for the marquee and 3 for the center. I also cut a strip of 3 to light of the movie screen.
The roof lights were connected in parallel so that they run the same pattern. This makes the effect look symmetrical.
I modified a grove cable so I could connect it to the breadboard. I just cut it in half and added header pins to it.
The marquee uses a long white LEGO technic beam to sit in front of the LEDs. I then added yellow LEGO semi-clear pieces as a finishing touch. This strip then connects to the second Wio Link interface. Now these lights can run independent of the roof lights. I used clear tape while prototyping. Through clever LEGO connections or hidden tacky tape, the electronics should look natural in the end.
The theater lighting uses the third Grove digital interface. The LEDs are attached to a 1×6 LEGO stud and the cable runs through the roof door.
The Wio Link will provide the API specific to that device firmware after all the modules have been added. It has a unique ID and token that will allow you to interact with it via REST.
Request method: POST
Arguments in URL:
Node-RED is a tool for wiring together hardware devices, APIs and online services in new and interesting ways.
Flow Source Code
Copy and import this flow into your Node-RED editor.
By creating a simple flow, I can send different commands by injecting the URL as a POST HTTP request.
The Inject and UI buttons set the payload to the API URL.
The function node simply copies the payload to the msg.url object which will be sent to the HTTP request node.
The UI provides an easy way to toggle the rainbow effect for both sets of lights.
the original post is from http://www.internetoflego.com/palace-cinema-wio-link-addressable-leds-node-red/