• Home
  • pcDuino
  • WiKi
  • Store
  • Distributors
  • Home
  • pcDuino
  • WiKi
  • Store
  • Distributors
HomeProjectUSB Freeform Arduino
Previous Next

USB Freeform Arduino

Posted by: Olva , October 30, 2016
Picture of USB Freeform Arduino
canArduino038.JPG
canArduino040.JPG
canArduino041.JPG
This is a project in attempting to improve it predecessor “Freeform Arduino” by putting it in an enclosure and having it serve the similar purposes as “Palm Arduino Kit” and “Palm Arduino II” which I can carry it in my pocket and be available to use, and to connect to easy available power source specifically USB port.
.
I designed this “USB Freeform Arduino” with USB connector to be enclosed inside a 35mm film canister.

The biggest challenge is how I couid fasten the “none PCB Arduino” to it own enclosure, in this case cylinder shape canister?
The answer was not an easy one. But the solution I found was an easy thing to do, and it was an excellent solution that we quite familiar with.

“How about glue it in!”, I said to myself.

Step 1: Parts and Tools

Picture of Parts and Tools
palmDuino.JPG
canArduino005.JPG
All the parts are about the same as used in it predecessor, “Freeform Arduino” except that I used film canister instead of the antistatic tube, with an addition USB type A connector.

Schematic shown below is comprised of the minimum components and could be used FTDI cable to upload the sketch.
On the actual USB Freeform Arduino did not  included the 1K resistor and 3mm LED that connected to pin D13 as in the schematic.

Parts

These are the minimum components to get Arduino up and running.
(1x)  ATmega168/328 preloaded with Arduino Bootloader
(1x) 16 Mhz Resonator
(2x) 0.1uF Ceramic Capacitors
(1x) 3mm red LED (Only needed for testing purpose only)
(1x) 1K Resistor
(1x) 10K Resistor
(1x) 6-pin Male Header (as the connector to FTDI cable to upload the sketch)
(2x)  1×14 Female Receptacle

Additional Materials:
Hookup Wire
35mm Film Canister
USB Standard type A cable (Male Connector)

Tools

Solder iron and Solder station
Diagonal Cutter
Pliers
X-Acto Knife
Wire Stripper
SolderSucker

Miniature Files
Hand Drill
Micro drill bit for Hand drill
Masking tape
Super Glue

The original post is from
http://www.instructables.com/id/USB-Freeform-Arduino/

Share!
Tweet

Olva

About the author

Leave a Reply Cancel reply

You must be logged in to post a comment.

Category

  • Home
  • pcDuino
  • WiKi
  • Store
  • Distributors