Course description: Draw a bunny ton the paper. When the jumper wire touches different parts of the the bunny, it will tell you which part you have touched.

Parts list:

1. 1  x pcDuino
2. 4  x 10K Ω resistance

Required items:

1. 1  x  painting tools (paper, pens, etc)

2. 4 x10K Ω resistor

3. Linker cable

4. Conductive aluminum foil

5. Double-sided tape

6. The Linker Base Shield

Preparation:

1. Draw a bunny  on a piece of paper

2. Connect the  four 10K Ω resistors in series as following:

3.Install the Linker Base Shield onto  pcDuino, and connect the linker cable as following:

4. Connect the different points of the resistor circuits  A,B,  to GND and VCC ends with the linker cable.

5. Turn around the paper, and let’s work on the other size of the paper. Fix the conductive aluminum foil to the skirt with the double-sides tape, fix the part D on its bike.

6. Then find jumper wire, connect  to the OUT port , the preparation work is done.