• Home
  • pcDuino
  • WiKi
  • Store
  • Distributors
  • Home
  • pcDuino
  • WiKi
  • Store
  • Distributors
HomepcDuinoQuick StartUse Vin on pcDuino to supply power to pcDuino1/2/3
Previous Next

Use Vin on pcDuino to supply power to pcDuino1/2/3

Posted by: admin , April 4, 2014

Many users are asking if it is possible to use Vin on pcDuino to supply power to pcDuino1/2/3. The answer is yes. The maximum voltage if 6V.  A good example can be found at:

https://s3.amazonaws.com/pcduino/book/Rover+-+A+WiFi+Video+Surveillance+Remote+Robot++Powered+by+pcDuino.pdf

Tags: Quick Start

Share!
Tweet

admin

About the author

Loading Facebook Comments ...

One Response to “Use Vin on pcDuino to supply power to pcDuino1/2/3”

  1. Log in to Reply
    Davey
    April 27, 2015 at 12:44 pm

    The power comes in on the microUSB connector on the bottom of the board. J1 on the cchematic in the DC_IN block.
    http://learn.linksprite.com/wp-content/uploads/2014/03/pcDuinoV3_Interface_Diagram2.jpg

Leave a Reply Cancel reply

You must be logged in to post a comment.

Category

Tags

  • Home
  • pcDuino
  • WiKi
  • Store
  • Distributors