Use Vin on pcDuino to supply power to pcDuino1/2/3 Posted by: admin , April 4, 2014 Many users are asking if it is possible to use Vin on pcDuino to supply power to pcDuino1/2/3. The answer is yes. The maximum voltage if 6V. A good example can be found at: https://s3.amazonaws.com/pcduino/book/Rover+-+A+WiFi+Video+Surveillance+Remote+Robot++Powered+by+pcDuino.pdf Share! Tweet admin About the author Please enable JavaScript to view the comments powered by Google+. Loading Facebook Comments ... Please enable JavaScript to view the comments powered by Facebook. One Response to “Use Vin on pcDuino to supply power to pcDuino1/2/3” Log in to Reply Davey April 27, 2015 at 12:44 pm The power comes in on the microUSB connector on the bottom of the board. J1 on the cchematic in the DC_IN block. http://learn.linksprite.com/wp-content/uploads/2014/03/pcDuinoV3_Interface_Diagram2.jpg Leave a Reply Cancel replyYou must be logged in to post a comment.
April 27, 2015 at 12:44 pm
The power comes in on the microUSB connector on the bottom of the board. J1 on the cchematic in the DC_IN block.
http://learn.linksprite.com/wp-content/uploads/2014/03/pcDuinoV3_Interface_Diagram2.jpg